Decommissioning
11.2 Permanent decommissioning
232
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
11.1.4
Removing engine preservation
• Remove the covers from the intake and exhaust openings of the en-
gine.
• Remove the anti-corrosion agent from the pulleys.
• Install the fan belt.
• Drain the preservation oil and add engine oil.
• Start up the engine.
• Check the belt tension after the first two hours of operation.
11.1.5
Putting the vehicle back into operation
• Remove engine preservation.
• Install the battery.
• Check tire inflation pressure.
• Remove the preservation from the piston rods of the hydraulic cylin-
ders.
• Set the vehicle on its wheels.
• Check the operation of the electrical system.
• Bleed the hydraulic system.
• Check the operation of the steering system and brakes.
11.2
Permanent decommissioning
11.2.1
Information on permanently putting the vehicle out of operation
If the vehicle is no longer used according to its designated use, ensure
that it is put out of operation and disposed of according to applicable reg-
ulations.
Do not allow the oil and oily wastes to get into the ground and stretches
of water! Dispose of different materials and consumables separately and
in an environmentally friendly manner!
11.2.2
Prior to disposal
• All applicable safety regulations relating to the decommissioning of
the vehicle must be complied with.
• Ensure that the vehicle cannot be operated from decommissioning
until further disposal.
• Ensure that there is no leakage of environmentally hazardous fluids
and consumables, and that the vehicle presents no other hazards at
its storage place.
• Secure the vehicle against unauthorized use! Close all openings
(doors, windows, engine cover) and secure the vehicle.
• Install all protective devices.
• Repair leaks in engine, tanks and hydraulic system.
• Remove the battery.
• Store the vehicle in a place that is protected against unauthorized ac-
cess.
To Next Page
Loading...