Malfunctions
Faults, causes, remedy 10.1
225
[en] | 05/2019 | 1000408123 | 4080T Basic Line | Operator’s Manual
10
Malfunctions
10.1
Faults, causes, remedy
10.1.1
Information on malfunctions
NOTICE
Ignoring a fault or error message
Ignoring a fault or an error message can result in damage to the vehicle.
► If the fault cannot be rectified by the measures described, contact an
authorized service center and have the fault or error rectified.
Repair work on the electrical systems and hydraulics of the vehicle may
only be carried out by an authorized service center.
If an error is to be reported to the authorized service center, have the fol-
lowing data ready:
• Control circuit
• SPN error code (Suspect Parameter Number)
• FMI error code (Failure Mode Identifier)
The data can be found in the error lists in the display Fault indications on
the display.
10.1.2
Troubleshooting aids
The information in this chapter is intended to help you locate faults and
identify them quickly and reliably so that they can be rectified.
Please contact your dealer if the malfunction cannot be remedied.
Repairs may only be carried out by authorized service centers and
trained personnel.
10.1.3
Possible faults and remedies on the engine
Error/fault Possible cause Remedy
Engine does not start Starting speed too low Check and charge the battery.
Check battery terminals for tight-
ness.
Engine does not start
Engine stops during operation
Operator is not sitting on the seat.
Malfunctioning seat switch
Sit down on the operator seat.
Have the seat switch replaced.
Continuous operation of the hy-
draulic connections is switched on
and operates against pressure
Switch off continuous operation of
the hydraulic connections.
Empty fuel tank Fill the tank and prime the fuel sys-
tem if necessary.
Fuel filter clogged.
Paraffin deposits in winter
Have the fuel filter changed.
Use winter diesel.
Leaking fuel line Tighten all screws and clamps.
10
To Next Page
Loading...