Weidemann Basic line 4080T - Page 96

Commissioning
6.5 Commissioning the vehicle
96
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
NOTICE
The starting motor may be damaged!
► Do not start the engine again immediately after stopping it. Wait at
least 15seconds.
► Abort the start attempt after a maximum of 15 seconds if the engine
does not start.
► Wait one minute between two start attempts.
Due to the hydrostatic drive system, the engine cannot be started by tow-
ing the vehicle.
Fuel, engine and hydraulic oil preheating recommended for operation at
outside temperatures below -10°C.
Running-in period
The engine must be use gently during the first 100 operating hours. Fol-
low the instructions below.
• Drive and work gently with the vehicle.
• Avoid loading the engine at idling speed.
• Do not run the engine continuously at maximum speed.
• Increase load gradually while varying the engine speed.
– The maximum speed is reached when the drive system has
reached a temperature between 20 and 30 °C.
• Observe the prescribed maintenance intervals and have the mainten-
ance carried out accordingly.
6.5.3
Battery master switch
NOTICE
Risk of technical damage
► Cover the opening with the protective cap to prevent humidity from
penetrating into the switch.
► Never operate the battery master switch under load.
► Do not insert the starting key unless the battery master switch is op-
erated.
► Do not operate the battery master switch unless the starting key is
removed.