Maintenance
9.1 Safety instructions for maintenance
176
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
Information on tools
• Only work with suitable and functional tools.
Information on cleaning work
• Clean units in the work area before starting work. The choice of the
cleaning agents depends on the material of the parts to be cleaned.
• Rubber parts and electrical components must not be cleaned with
solvents or steam. Water can cause short circuits in the electrical sys-
tem and cause new hazards.
• Do not use solvents that give off harmful or flammable vapors.
• Avoid skin contact with cleaning agents!
• Wear protective equipment.
Information on handling flammable liquids
• Do not smoke and avoid open fire when handling flammable liquids.
• Do not use water to extinguish fires on the vehicle or burning liquids.
• Use suitable extinguishing agents, such as powder, carbon dioxide or
foam fire extinguishers.
• Always call the fire department in the event of a fire.
Information on handling fuels, oils and greases
• Burn hazard due to hot lubricating oil or hydraulic oil.
• Avoid skin and eye contact with oil and grease.
• Wear protective equipment.
• Do not use fuel or solvents to clean your skin.
• Rectify any oil or fuel leaks immediately.
• Do not allow the oil and oily wastes to get into the ground or stretches
of water.
• Absorb the escaping oil or fuel immediately with a binding agent, and
dispose of it in an environmentally friendly manner and separately
from other waste.
• Even biodegradable, “environmentally friendly” oil must be disposed
of separately, just like every other type of oil.
To Next Page
Loading...
