Safety
4.9 Maintenance
32
Operator’s Manual | 4080T Basic Line | 1000408123 | 05/2019 | [en]
4.8.3
Transportation
• For the safe transportation of the vehicle:
– The transport vehicle must have a sufficient bearing load and
loading surface.
– The maximum weight rating of the transport vehicle must not be
exceeded.
• Use only lifting and fastening gear certified by a test or certification
body, observe the inspection intervals. Adhere to the inspection inter-
vals .
• Do not use any lifting and fastening gear that is dirty, damaged or not
of sufficient size.
• In order to secure the vehicle on the loading surface, use only the
fastening points provided for this purpose.
• Ensure that nobody is in or on the vehicle during transportation.
• Observe the national regulations.
• Bear in mind the weather conditions (e.g. ice, snow).
• Ensure the minimum load on the steering axle(s) of the transport
vehicle, and ensure an even load distribution.
4.9
Maintenance
4.9.1
Maintenance
• Observe the intervals prescribed by law and those specified in this
operator’s manual for routine checks/inspections and maintenance.
• For maintenance activities, ensure that all tools and service center
equipment are adapted to the performance of the task described in
this operator’s manual.
• Do not use any damaged or malfunctioning tools.
• Have hydraulic hoses and lines replaced by an authorized service
center within stipulated intervals even if no visual defects can be de-
tected.
• The vehicle and the engine must be stopped during maintenance.
• Once maintenance is over, correctly install safety equipment again
that has been removed.
• Wait for the vehicle to cool down before touching components.
To Next Page
Loading...
