First commissioning
20 Operating Manual
3.4 Connections/controls at the front
Headphone
To the left of the submanual is headphone output HEADPHONE.
Connect your standard stereo headphones here.
Stereo jack: 6.3 mm
Recommended impedance: not too low, we recommend between 80 and 250 ohms.
Once you have plugged in the headphones, the two AUDIO outputs are muted in the default setting. This
means that the connected active boxes are no longer to be heard. To change this default setting, see the
Programming Manual SONIC.
Pitch Bend and Modulation Controller
On the left side of the submanual you will find the control unit for the pitch bend and the modulation wheel.
Pitch change downwards or upwards. The Pitch
Bend always jumps back into the middle
position.
position below -> no change
position above -> full effect
Change of sound, mode of action depending on
the sound with change of vibrato or the filters
or e.g. the volume of a new sound element.
Which sounds the two controllers have an effect on can be adjusted separately and stored in a total
presets.
USB-Connecters
[USB = Universal Serial Bus = Connecting from a computer to external accessories]
On the right side of the panel aperture are four USB ports to use your USB memory sticks (for loading/importing
and saving/exporting). Of course, you can also connect a USB mouse or a UBS keyboard there.
You do not need to log your USB stick off the (Windows) system before unplugging/removing it.
DVD/Blu-ray-Drive (not OAX 1)
To Next Page
Loading...
Need help?
General
