OAX-System 63
Once you have briefly tapped the Chorus button, the display will appear to set the Chorus effect.
For the MANUALS, ACCOMPANIMENT and DRUM areas,
you will find a controller with which you can adjust the
output of the chorus effect device, also called RETURNS.
Small tip: As long as no sound is selected that also uses
a chorus, there may be no change to be heard. To set
the chorus effect per sound, see the chapter for EASY
mode for easy mode.6.2 „The EASY Manual Controller“
or PROFI mode in chapter 7.3.1 „The Standard Control“.
If you do not make any settings, the display will
disappear after a few seconds. When the HOLD display
button is pressed, the display remains permanently
displayed.
You can use the appropriate slider to vary the volume of
the chorus effect. With RESET, you reset the volume to
the value stored in the Effects program.
To change the Chorus program, briefly tap the
appropriate name field. Here in the example on
"Chorus 3" in the manuals section.
The selection box of possible chorus programs
opens. Once you have programmed your own
effect settings and given a name, these effect
presets will also appear in this list.
After you select a new program, the window
closes and the newly selected chorus program is
active.
If you don't make a selection, the window will
automatically close after a few seconds.
Note: You can find out how to program your
own effects in the chapter 7.10 Effects.
4.8.3.4 Fast operation Delay
To Next Page
Loading...
Need help?
General
