OAX-System 61
CHORUS and DELAY control panel buttons, you can quickly influence the overall volumes and the
corresponding effect program.
ATTENTION: Once you have made settings here, these values are saved into a total preset. Please note,
however, that the settings in the areas of accompaniment and drums are only saved in a total preset if
an accompaniment is also saved. This means that when saving a Total Preset, the accompaniment area
must be checked.
Once you have briefly tapped the REVERB button, the following display appears:
For the MANUALS, ACCOMPANIMENT and DRUMS areas, you will find controllers for reverb 1 and reverb 2,
which allow you to adjust the outputs of the effect devices, also called RETURNS. For the vast majority of
sounds, the reverb 1 has been used. So don't be surprised that not much happens when you push up Reverb
2.
Small tip: How to use both reverberation paths, you can find out for the EASY mode in the chapter6.2 „The
EASY Manual Controller“ or for PROFI mode in the chapter 7.3.1 „The Standard Control“.
If you do not make any settings, the display will disappear after a few seconds. When the HOLD display
button is pressed, the display remains permanently displayed.
You can use the appropriate sliders to vary the volume of the reverb devices.
With RESET, you reset the volume to the value stored in the Effects program.
To Next Page
Loading...
Need help?
General
