Commissioning en
Installation and operating instructions Wilo-Control EC/ECe-Booster 67
7.5 Quick access to “Easy Actions”
The following functions can be called up using the Easy Actions menu:
Reset the current error message
NOTICE!Menu point is only shown when an error is present!
Manual operation pump 1
If the operating button is pressed, pump 1 runs.
If the operating button is released, the pump switches off. The last
set operating mode is active again.
Manual operation pump 2
If the operating button is pressed, pump 2 runs.
If the operating button is released, the pump switches off. The last
set operating mode is active again.
Manual operation pump 3
If the operating button is pressed, pump 3 runs.
If the operating button is released, the pump switches off. The last
set operating mode is active again.
Pump 1 switch off.
Corresponds to the “off” value in menu 3.02.
Pump 2 switch off.
Corresponds to the “off” value in menu 3.03.
Pump 3 switch off.
Corresponds to the “off” value in menu 3.04.
Automatic mode, pump 1
Corresponds to the “Auto” value in menu 3.02.
Automatic mode, pump 2
Corresponds to the “Auto” value in menu 3.03.
Automatic mode, pump 3
Corresponds to the “Auto” value in menu 3.04.
7.6 Factory settings
To reset the switchgear to the factory settings, contact customer service.
8 Commissioning
8.1 Operator responsibilities
NOTICE
Observe additional documentation
Carry out the commissioning measures in accordance with the installation and oper-
ating instructions for the overall system!
Observe the installation and operating instructions for the connected products
(sensors and pumps) as well as the system documentation!
▪Provide installation and operating instructions at the switchgear or at a place specially
reserved for it.
▪Make the installation and operating instructions available in a language the personnel
can understand.
▪Make sure that the installation and operating instructions have been read and under-
stood by all personnel.
▪The installation site of the switchgear is overflow-proof.
▪The switchgear is properly fused and earthed.
▪Safety devices and precautions (incl. emergency off) for the entire system are switched
on and have been checked for problem-free operation.
▪The switchgear is suitable for use under the specified operating conditions.
To Next Page
Loading...
Need help?
General
