To Level Motorhome:
• If applicable place the gear selector in neutral, apply the parking brake and
shut off the engine.
• Turn the ignition switch to the ON position without the engine running.
• Turn the right hand rocker power switch on the jack control console to the
“ON” position. The green light should be lit.
Rocker switch positions are as follows:
Front - System ON.
Center - System OFF.
Rear - Returns all jacks automatically to their retracted positions.
• Indicator light functions are as follows:
Green Light - Indicates system is ON.
Flashing red Light - Indicates jack(s) is extended.
Flashing yellow Light - Indicates jack(s) is retracted.
• Level motorhome, using the front jack first, so that the bubble is centered
in the level indicator. Push the rocker switch to extend or retract a partic-
ular jack as marked on control panel. The red light should be flashing.
When level, turn the rocker power switch and ignition switch off.
To Retract Jacks For Travel:
• Turn the ignition switch to the ON position without the engine running.
• Position the right hand rocker power switch in the rear “Retract All” posi-
tion. All jacks should retract, the yellow light should start flashing and the
red light should go out when all jacks are retracted.
• Place the jack control in the center position to turn the leveling system off.
• Start the engine and allow the air pressure to build up to normal.
• Visually check each jack to make sure they are completely retracted before
moving the motorhome.
CAUTION: Do not rely solely upon warning lights. It is the opera-
tor’s responsibility to check that the motorhome is at the proper
ride height before moving the motorhome.
Chassis Information
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
WINDSOR
10•274