Winkhaus blueMatic EAV4 - Use contrary to the intended purpose

blueMatic EAV4 / EAV4+ 510736410Installation, Operating and
Maintenance Instructions
1
EN
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.com ∙ Subject to technical changes
The locking systems are not designed to absorb or compensate for changes in
shape or changes in the closing mechanism of the door caused by fluctuation
in temperature or in the structure of the building.
Waterproof doors or doors designed to contain aggressive corrosion-promo-
ting air require special door furniture.
The locking systems are incorrectly used – that is used contrary to the terms de-
scribed above – in evident in particular, if:
• the instructions on the intended use are not being followed;
• the problem-free operation is hindered due to the installation of external
objects and/or objects that are not purpose-conformant in the opening
zone, the locking system or within the keeps;
• the locking system or the keep is manipulated in such a way that their design;
• mode of operation or function is changed;
• the door is drilled through in the area of the lock housings or of the lock rod
once the lock has been installed;
• the dead bolt projection or other locking components are employed
contrary to their intended purpose, as a means to hold the door opened;
• the handle’s wire is driven through the spindle with force;
• the lock components are installed improperly or are tampered with, e.g. by
painting over moveable parts such as the bolt or the latch;
• loads exceeding those of normal manual force are transmitted via the safety
key onto the lock system;
• perform a manual or mechanical locking or unlocking during the motor is
working;
• the handle is turned counterclockwise or if a force greater than 150 N is
exerted on the handle;
• the clearance between the door frame and sash is increased or decreased,
which would for instance result from readjusting the hinge plates or from
lowering the door;
• if auxiliary lifting tools or other tools are used to open or close the lock;
• the handle and key are used at the same time;
• the lock is opened/closed with objects not intended for that purpose;
• the size of the door opening deviates from the specifications prescribed.
1.3 Use contrary to the intended purpose