Winkhaus blueMatic EAV4 - Cable transition T-HT KÜ M1188

Attention! Leave some spare cable (loop) directly behind the
cable transition to allow for the spring to expand!
Notice: The cable transition fitting piece simplifies installation
in timber doors. It saves plodding with the chisel.
This cable transition is qualified for doors with 18 mm fixed
pivotal point and 180° opening. Do not bend the cable
transition and do not undershoot the bending radius of
Ø 25 mm.
510736462
3
EN
blueMatic EAV4 / EAV4+ Installation, Operating and
Maintenance Instructions
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.com ∙ Subject to technical changes
3.3.3 Cable transition T-HT KÜ M1188
Installation sequence
• Cut on oblong hole in the door frame according to specifications (refer to
figures 3.3.3-3/3.3.3-4)
• Run the cable through the door frame
• insert and screw cable transition (with cable transition fitting piece and
radius shimming plate)
Figure 3.3.3-1: Cable
transition fitting piece
Figure 3.3.3-2: Radius
shimming plate