Wolf BWL-1S-07 - Electrical Connection

36 3064298_201805
Electricalconnection
20 Electricalconnection
20.1 Generalinformation
Theinstallationmaybecarriedoutonlybyanapprovedelectricalcontractor.Observe
VDEregulations[Germany]andalllocalregulationsofyourpowersupplyutility.
Anomnipolarisolatorwithatleast3mmcontactseparationmustbeintegratedinthe
powercableupstreamoftheappliance.
Ifusingresidualcurrentprotection(groundfaultcircuitinterrupterorRCD),useatype
BAC/DC-sensitiveresidualcurrentprotectivedevice,asthisistheonlytypesuitedto
DCresidualcurrents.
TypeAresidualcurrentprotectivedevicesarenotsuitable.
Donotroutesensorleadsalongside230Vor400Vcables.
Dangerthrough'live'electricalcomponents.
Pleasenote:TurnOFFtheON/OFFswitchbeforeremovingthecasing.
NevertouchelectricalcomponentsorcontactswhentheON/OFFswitchisintheONposition.
Thereisadangerofelectrocution,resultinginarisktohealthordeath.
Themainterminalsare"live",evenwhentheON/OFFswitchisintheOFFposition.
Duringservicingandinstallationwork,isolatetheentiresystemfromthepowersupply
acrossallpoles,otherwisetherewillbeariskofelectrocution.
Beforeconnectingtheappliancetothepowersupply,ensurethatallelectricalcoversand
protectivedevicesarefullyinstalled.
Connectingcables,installationductsortubes,etc.,mustbeweatherproof,UV-resistantand
protectedfrommechanicaldamage.
Front panel with integral
ON/OFF switch