3064298_201805 7
Safetyinstructions/standardsandregulations
1.2 Standards/regulations
Observeallstandardsandguidelinesapplicabletotheinstallationandoperation
ofthisheatingsysteminyourcountry.
Observetheinformationontheheatpumptypeplate.
Thefollowinglocalregulationsmustbecompliedwithduringinstallationandoperation
oftheheatingsystem:
• Siting conditions
• Electrical connection to the power supply
• The regulations and standards regarding the safety equipment of the water heating system
• DHW installation
Thefollowinggeneralregulations,rulesandguidelinesmustbeobservedforinstallationinparticular:
• EN 806 Specifications for installations inside buildings conveying potable water
• EN 1717 Protection against pollution of potable water installations
• EN 12831 Heating systems in buildings - Method for calculation of the design heat load
• EN 12828 Heating systems in buildings - Design for water-based heating systems
• VDE 0470/EN 60529 Degrees of protection provided by enclosures (IP rating)
• VDI 2035 Prevention of damage in hot water heating systems
- Scale formation (Sheet 1)
- Corrosion by water (Sheet 2)
ThefollowingalsoapplytoinstallationandoperationinGermany:
• DIN 8901
• DIN 1988 Drinking water supply systems
• VDE 0100 Erection of power installations with rated voltages below 1000 V
• VDE 0105 Operation of high voltage systems, general stipulations
• Energy Savings Act (EnEG) and related ordinances:
Energy Saving Ordinance (EnEV) (currently applicable version)
ThefollowingapplytoinstallationandoperationinAustriainparticular:
• ÖVE regulations
• Provisions of the ÖVGW and the corresponding Austrian standards
• Regulations and requirements of the local power supply utility (PSU)
• Provisions of regionally applicable building regulations
• Minimum heating water requirements in accordance with ÖNORM H5195-1 must be observed
ThefollowingapplytoinstallationandoperationinSwitzerlandinparticular:
• SVGW regulations
• BUWAL and local regulations must be observed
• NEV (SR 743.26)