Xerox 6204 - Setting up the [More Features] Selections; Scan Width

4 Scan
94 Xerox 6204 Wide Format Solution
Scan
4
Setting Up the [More Features] selections
You can configure items such as scanned image size and the scan start position on the
[More Features] screen. For more information, refer to the following:
Scan Width........................................................................................................................................94
Scan Offset........................................................................................................................................95
Invert Image ......................................................................................................................................96
Mirror Image......................................................................................................................................97
Preview..............................................................................................................................................99
Scan to Print....................................................................................................................................100
1 Select the [More Features] tab and configure each feature.
2 Set up the features on the [More Features] tab for the document(s) you will be
scanning.
Scan Width
The 6204 Wide Format Solution is, by default, set up to scan standard size originals. If
you wish to copy a non-standard width original, define the width using the [Scan Width]
selection. This feature allows you to define a variable scan width of from 8.2 to 36
inches, in increments of 0.1 inch. The factory default setting is [Standard Width].
Procedure
1 Select [Scan Width] on the top [1] [More
Features] tab.
The [Scan Width] screen will display.