Xerox 6204 - Sleep

6 System Setup
136 Xerox 6204 Wide Format Solution
System Setup
6
2. Sleep
The procedure for setting up the [Sleep mode] follows. The setting range is 5 to 240
minutes. The factory default setting for [2. Sleep] is 30 minutes.
Procedure
1 Select the [Setup] button on the [Menu] screen.
The [Setup] menu will display.
2 Select [Timers] on the [Setup] menu.
The [Timers] menu will display.
3 Select [2. Sleep].
The [Auto Power Saver] screen will display.
4 Using the numeric keypad or the scroll buttons,
enter the desired [Sleep Mode] setting, and then
press [Save].
Note: This setting is the amount of time that must elapse
since the last user operation, e.g., a button press or
document scan, until the machine enters the [Sleep
mode].
Note: The [Sleep Mode] setting cannot be less than the
[Low-Power Mode] setting.
5 Select [Close] on the [Timers] menu to return to the [Setup] menu.