Xerox ColorQube 8900 - Troubleshooting Paper Jams; Multiple Sheets Pulled Together; Paper Misfeeds

Troubleshooting
210 ColorQube 8700/8900 Color Multifunction Printer
User Guide
Troubleshooting Paper Jams
This section includes:
 Multiple Sheets Pulled Together .............................................................................................................................. 210
 Paper Misfeeds ................................................................................................................................................................ 210
 Jams in the Document Feeder .................................................................................................................................. 211
 Paper Jam Message Stays On ................................................................................................................................... 211
 2-Sided Printing Jams ................................................................................................................................................... 211
Multiple Sheets Pulled Together
Probable Causes
Solutions
The paper tray is too full.
Remove some of the paper. Do not load paper past the fill line.
The edges of the paper are not even.
Remove the paper, align the edges, and then reload it.
The paper is moist from humidity.
Remove the moist paper and replace it with new, dry paper.
Too much static electricity is present.
 Try a new ream of paper.
 Do not fan transparencies before loading them in the paper tray.
Unsupported or incorrect paper.
Use only Xerox
®
approved paper. For details, see Supported Paper
on page 44.
The relative humidity of the room is too high.
Feed paper one sheet at a time.
Paper Misfeeds
Probable Causes
Solutions
The paper is not correctly positioned in
the tray.
 Remove the misfed sheet and reposition the remaining paper
properly in the tray.
 Adjust the paper guides to fit the paper size.
The paper tray is too full.
Remove some of the paper. Do not load paper past the fill line.
The paper guides are not correctly adjusted to
the paper size.
Adjust the paper guides in the tray to match the size of the paper.
The tray contains warped or wrinkled paper.
Remove the paper, smooth it out, and reload it. If it still misfeeds, do
not use that paper.
The paper is moist from humidity.
Remove the moist paper and replace it with new, dry paper.
Using paper of the wrong size, thickness,
or type.
Use only Xerox
®
approved paper. For details, see Supported Paper on
page 44.