Control Panel Menus
WorkCentre 6505 Color Laser Multifunction Printer
User Guide
153
Fax Settings
Use this menu to specify fax settings.
Host Access
List
Limits the IP addresses that can access this printer.
Initialize NVM Initializes network data stored in NVM. After executing this function and restarting the
printer, all network settings are reset to their default values.
Adobe Protocol Specifies the Adobe protocol:
•Auto
•Standard
•BCP
•TBCP
•Binary
Item Description
Ans Select Specifies the receiving mode:
• FAX Mode: A fax is automatically received.
• TEL/FAX Mode: When the printer receives an incoming fax, the external telephone rings
for the time specified by Auto Ans. TEL/FAX, then the printer automatically receives the
fax. If incoming data is not a fax, the printer beeps the internal speaker.
• Ans/FAX Mode: The printer can share one telephone line with an answering machine. In
this mode, the printer monitors the fax signal and picks up the line if there are fax tones.
If the phone communication in your country is serial, this mode is not available.
• DRPD Mode: Before using the Distinctive Ring Pattern Detection (DRPD) option,
distinctive ring service must be installed on your telephone line by the telephone
company. After the telephone company provides a separate number with a distinctive
ring pattern, configure the fax setup to monitor for that specific ring pattern.
• TEL Mode: Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external phone, then pressing the remote receive code. You can also set
OnHook to On, allowing you to hear voice or fax tones from the remote machine, then
press Start.
Auto Answer
Fax
When FAX Mode is enabled, specifies how long the printer waits before answering an
incoming call. Specify values from 0 through 255 seconds.
Auto Ans.
TEL/FAX
When TEL/FAX Mode is enabled, specifies how long the printer waits before answering an
incoming call. Specify values from 0 through 255 seconds.
Auto Ans.
Ans/FAX
When ANS/FAX Mode is enabled, specifies how long the printer waits before answering an
incoming call. Specify values from 0 through 255 seconds.
Item Description
To Next Page
Loading...
Need help?
General
