21
RX-V3300/DSP-AZ2
RX-V3300/DSP-AZ2
• Functions in DIAG mode
In addition to the DIAG menu items, functions as listed
below are available.
• Input selection, 6CH input
• Center/Rear/Rear Center/Sub-woofer level adjustment
• Muting
• Speaker relay A/B
• Power on/off
• Master volume
* Functions related to the tuner and the set menu are not
available.
* It is possible to confirm Menu No.14 IF STATUS while
keeping the signal process (operation status) of each
DIAG menu by using the input mode key of the main
unit.
• Initial settings used to start DIAG
The following initial settings are used when starting DIAG.
When DIAG is canceled, these settings are restored to
those before starting DIAG.
• Master volume: -40dB
• Input: DVD (6CH INPUT OFF)
• Effect level: 0dB
• Audio mute: OFF
• Speaker relay A/B: ON
• Speaker setting: LARGE / BASS OUT = BOTH
• DIAG menu: YSS938 (1. ANALOG BYPASS)
●ダイアグ中の機能
●ダイアグ開始時の初期設定
To Next Page
Loading...
Need help?
General
