Yamaha DSP-AZ2 - Soft Switch Function Settings; SW Mode and Model Settings; Tuner and Zone 2 Settings; RDS and Video Format Settings

40
RX-V3300/DSP-AZ2
RX-V3300/DSP-AZ2
17. SOFT SW
This menu is used to switch the function settings on
P.C.B. through the software so as to activate the
product.
The protection function follows the P.C.B. settings.
When connected to AC or in the maker preset state, the
unit is initialized to the P.C.B. setting. Display of each
function after initialization varies depending on settings
on P.C.B. The operation mode can be changed by
selecting the sub-menu and then using the EFFECT
key. With SOF selected for the SW mode, the settings
become effective.
MODEL SETTING
V1300, V2300, V3300 or AZ2 can be selected.
TUNER DESTINATION
J, UC, ALG or R can be selected.
TUNER EXIST
NOT or EXIST can be selected.
RDS EXIST
NOT or EXIST can be selected.
ZONE 2 EXIST
NOT or EXIST can be selected.
VIDEO FORMAT
NTSC or PAL can be selected.
SW MODE
PCB or SOFT can be selected.
17.SOFTSW








MODELSETTING


TUNERDESTINATION

TUNEREXIST

RDSEXIST
NOTまたはEXISTを選択できます。
ZONE2EXIST

VIDEOFORMAT

SWMODE
