7-13
1
2
3
4
5
6
7
8
9
10
SPECIFICATIONS
WIRE ROUTING DIAGRAM
1. Hose clamp 8. Wire harness
2. Inlet pipe 2 9. Purge hose 2
3. Fuel injector #2 10.3 WAY joint
4. Fuel injector pipe 2 11.Purge hose 1
5. Fuel injector #1 12.Plastic locking tie
6. Inlet pipe 1 13.Fuel injector pipe 1
7. High-pressure fuel pump
A. Fuel injector pipe 1 connector installation details
• Insert the fuel injector pipe 1 connector until a click is heard, and then make sure that the connector is
not disconnected.
• When inserting the fuel injector pipe 1 connector, pay attention not to prize.
B. Insert the purge hose 1, purge hose 2, cap all the way into the 3 WAY joint.
C. Make sure that there is no looseness or tension of the lead.
D. Insert the protector side of the purge hose 2 all the way into the pipe of the fuel pump.
E. Install the cap in the direction shown in the illustration.
F. Keep the length shown in the illustration to 0–2.0 mm (0–0.08 in) and cut off the end of the plastic lock-
ing tie.
G. The binding area of the plastic locking tie should be on the outside of the engine.
H. 2.0–4.0 mm (0.08–0.16 in)
I. Insert the fuel injector pipes until it contacts the inlet pipes.
J. Install the yellow painted portion in the direction shown in the illustration.
K. Install the white painted portion in the direction shown in the illustration.
To Next Page
Loading...
