IMPORTANT INFORMATION
1-6
1
2
3
4
5
6
7
8
9
10
GENERAL INFORMATION
Tightening torque
Be sure to follow torque specifications. When tightening
bolts, nuts or screws, start with the largest-diameter fas-
tener and work from an inner position to an outer position
in a crisscross pattern.
Notes on disassembly and assembly
• Parts should be cleaned in solvent and blown dry with
compressed air after disassembly.
• Contact surfaces of moving parts should be oiled when
reassembled.
• Make sure that the parts, move smoothly after each sec-
tion of the machine is assembled.
ALL REPLACEMENT PARTS
We recommend the use of genuine Yamaha parts for all
replacements. Use oil and/or grease, recommended by
Yamaha, for assembly and adjustment.
GASKETS, OIL SEALS, AND O-RINGS
1.
All gaskets, seals, and O-rings should be replaced
when an engine is overhauled. All gaskets surfaces,
oil seal lips, and O-rings must be cleaned.
2.
Properly oil all mating parts and bearings during reas-
sembly. Apply grease to the oil seal lips.
To Next Page
Loading...
