7-15
1
2
3
4
5
6
7
8
9
10
SPECIFICATIONS
WIRE ROUTING DIAGRAM
1. Crankshaft position sensor 12.Fuel injector #2 coupler
2. Ignition coil #2 13.Manifold absolute pressure sensor lead
3. Throttle position sensor lead 14.Ignition coil #2 coupler
4. Engine temperature sensor lead 15.Fuel injector #1 lead
5. O
2
sensor lead 16.Ignition coil #1 lead
6. Ignition coil #1 coupler 17.Plastic locking tie
7. Fuel injector #1 coupler 18.Fuel injector #2 and crankshaft position sensor
lead
8. Ignition coil #1 19.High-pressure fuel pump lead and oil pressure
switch lead
9. Wire harness 20.Ignition coil #2 lead
10.Stator 21.Fuel injector #2 lead
11.Crankshaft position sensor coupler 22.Intake manifold
A. Install the leads so that they overlap each other.
B. Lock the fuel injector coupler after installation.
C. Install the lead as shown in the illustration.
D. Gap between crankshaft position sensor and rotor should be 0.5–1.5 mm (0.02–0.06 in).
E. Installation details of ignition coil and coupler
F. After installing the coupler, insert it until it is locked.
G. Boss
H. Align the wire harness with the boss of the intake manifold.
I. Branch
J. Position the plastic locking tie between the projections as shown in the illustration.
K. Projection
L. Allowance 2.0 mm (0.08 in) or less
M. Direction of upper surface of the engine
N. Install the lock of the plastic locking tie as shown in the illustration.
To Next Page
Loading...
