7-17
1
2
3
4
5
6
7
8
9
10
SPECIFICATIONS
WIRE ROUTING DIAGRAM
1. Rectifier/regulator 15.Fuse (10 A) coupler
2. Earth terminal 16.Fuse (30 A) coupler
3. ECU 17.Starter motor
4. ECU coupler (black) 18.Plastic locking tie
5. ECU coupler (gray) 19.Throttle body
6. Fuel injector #1 lead 20.Throttle position sensor lead
7. Ignition coil #1 lead 21.Engine temperature sensor lead
8. Throttle position sensor coupler 22.O
2
sensor lead
9. Engine temperature sensor 23.Starter motor lead
10.Engine temperature sensor coupler 24.Starter relay lead
11.O
2
sensor coupler 25.Rectifier/regulator lead (white)
12.Spark plug cap 26.Rectifier/regulator lead (red)
13.Stay 27.Rectifier/regulator lead (black)
14.Fuse (10 A) coupler
A. Tighten the earth terminal together with the mounting bolt in the direction shown in the illustration.
B. Install the spark plug cap in the direction shown in the illustration.
C. Install in the stay.
D. Tighten together with the vehicle battery positive terminal.
E. Direction of upper surface of the engine
F. Allowance 2.0 mm (0.08 in) or less
G. Install the leads so that they do not overlap each other.
H. Starter motor lead installation details
I. Engine side
J. Rectifier/regulator lead installation details
K. Connect with the stator lead connector (female). (Polarity does not matter)
L. Connect with the wire harness connector (male/black).
M. Connect with the wire harness connector (male/red).
To Next Page
Loading...
