YASKAWA SGM-A3 - Using the Functions; Operation in Alarm Trace-Back Mode

4.2 Using the Functions
183
4.2 Using the Functions
This section describes how to use the basic operations described in section 1 to operate
and adjust the motor.
4.2.1 Operation in Alarm Trace-back Mode 183...............................
4.2.2 Operation Using the Digital Operator 186...............................
4.2.3 Autotuning 188......................................................
4.2.4 Reference Offset Automatic Adjustment 195.............................
4.2.5 Speed Reference Offset Manual Adjustment Mode 197...................
4.2.6 Clearing Alarm Trace-back Data 200...................................
4.2.7 Checking Motor Type 201.............................................
4.2.8 Checking Software Version 201.......................................
4.2.1 Operation in Alarm Trace-back Mode
1) The alarm trace-back mode displays up to ten alarms which occurred previously. By al-
lowing confirmation of what alarm occurred when, it is a useful aid to speed up trouble-
shooting.
Alarm Sequence Number Alarm Code
The higher the number,
the older the alarm data
See the table of
alarms on page 185.
NOTE The alarm trace-back data is not cleared on alarm reset or when the Servopack power is
turned OFF. This does not adversely affect operation.
The data is cleared using the special mode: Clear alarm trace-back data.
Refer to sub-section 4.2.6 for details.
4