7.9 Gain Adjustment of Analog Monitor Output (Fn00D)
7-17
7
Utility Functions (Fn)
(3) Operating Procedure
Use the following procedure to perform the gain adjustment of analog monitor output.
Step
Display after
Operation
Keys Operation
1 Press the MODE/SET Key to select the utility function.
2 Press the UP or DOWN Key to select Fn00D.
3
Press the DATA/SHIFT Key for approximately one second.
The screen shown on the left will be displayed.
4
Press the DATA/SHIFT Key. Gain adjustment data will be
displayed as shown on the left.
5 Press the UP or DOWN Key to change the gain.
6
Press the DATA/SHIFT Key to return to the screen as
shown on the left.
7
Press the MODE/SET Key to switch to channel 2 (analog
monitor 2) monitor output.
8
Press the DATA/SHIFT Key. Gain adjustment data will be
displayed as shown on the left.
9 Press the UP or DOWN Key to change the gain.
10
Press the DATA/SHIFT Key for approximately one second.
"Ch2-G" is displayed, and then "Fn00D" is displayed again.
MODE
SET
DATA
MODE
SET
DATA
MODE
SET
DATA
MODE
SET
DATA
MODE
SET
DATA
MODE
SET
DATA
MODE
SET
DATA
MODE
SET
DATA
To Next Page
Loading...
