Yealink T29G

Configuring Advanced Features
453
Parameters
Permitted Values
Default
Phone User Interface:
None
To configure the 802.1X authentication via web user interface:
1. Click on Network->Advanced.
2. In the 802.1x block, select the desired protocol from the pull-down list of 802.1x
Mode.
a) If you select EAP-MD5:
1) Enter the user name for authentication in the Identity field.
2) Enter the password for authentication in the MD5 Password field.
b) If you select EAP-TLS:
1) Enter the user name for authentication in the Identity field.
2) Leave the MD5 Password field blank.
3) In the CA Certificates field, click Browse to select the desired CA certificate
(*.pem, *.crt, *.cer or *.der) from your local system.
4) In the Device Certificates field, click Browse to select the desired client (*.pem
or *.cer) certificate from your local system.