Administrator’s Guide for SIP-T2_Series_T4_Series IP Phones
512
Directory Template
Super Search Template
Local Contact File
Remote XML Phone Book
The replace rule template helps with the creation of multiple replace rules. After setup,
place the replace rule template to the provisioning server and specify the access URL in
the configuration files.
When editing a replace rule template file, learn the following:
<DialRule> indicates the start of the template file and </DialRule> indicates the
end of the template file.
Create replace rules between <DialRule> and </DialRule>.
When specifying the desired line(s) to apply the replace rule, the valid values are 0
and line ID. The digit 0 stands for all lines. Multiple line IDs are separated by
commas.
At most 100 replace rules can be added to the IP phone.
The expression syntax in the replace rule template is the same as that introduced
in the section Dial Plan on page 131.
Procedure
Use the following procedures to customize a replace rule template.
To customize a replace rule template:
1. Open the template file using an ASCII editor.
2. Add the following string to the template, each starting on a separate line:
<Data Prefix="" Replace="" LineID=""/>
Where:
Prefix="" specifies the numbers to be replaced.
Replace="" specifies the alternate string instead of what the user enters.
LineID="" specifies the desired line(s) for this rule. When you leave it blank or enter
0, this replace rule will apply to all lines.
3. Specify the values within double quotes.
4. Place this file to the provisioning server.
The following shows an example of a replace rule template:
<DialRule>
<Data Prefix="1" Replace="05928665234" LineID=""/>
To Next Page
Loading...
Need help?
General
