Yealink T29G

Administrator’s Guide for SIP-T2_Series_T4_Series IP Phones
42
http://<phoneIPAddress>/servlet
?p=network&q=load
Phone User Interface
Configure PPPoE on the IP phone.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.internet_port.type
0, 1 or 2
0
Description:
Configures the Internet (WAN) port type for IPv4 when the IP address mode is
configured as IPv4 or IPv4 & IPv6.
0-DHCP
1-PPPoE (not applicable to SIP-T42G/T41P IP phones)
2-Static IP Address
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN
Port->IPv4
network.pppoe.user
String within 32
characters
Blank
Description:
Configures the user name for PPPoE connection when the IP address mode is
configured as IPv4 or IPv4 & IPv6, and the Internet port type is configured as PPPoE.
Example:
network.pppoe.user = Xmyl0592123
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Basic->IPv4 Config->PPPoE->User Name
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN
Port->IPv4->PPPoE IPv4 Client->PPPoE User