6-19
IM 04P01B01-01E
Setup Operations for Convenient Functions (Setting Mode)
6
Feed
The available setting range is 0 to 50 mm.
POC output
You can eject the portion that is not recorded when recording stops with the pen offset
compensating recording function.
POC speed
Select the chart speed when ejecting the portion that was not recorded.
Chart speed: Feeds at the specified chart speed.
450mm/h: Fixed to feed at 450 mm/h.
Note
The following operations are performed when using the header printout function (/BT1 option).
• When the power is interrupted and is reintroduced, recording always stops. End
printout/End printout 2 is not performed.
• When recording stop detection is performed (option /F1), recording and printout stop.
When chart paper is inserted, the instrument operates as follows.
• When detected during Start printout and recording: Recording starts after Start printout.
• When detected during End printout: When stopped, End printout/End printout 2 is not
performed.
• Until Start printout/Start printout 2 and End printout/End printout 2 finishes, the instrument
cannot transition to the next operation.
• When recording is started, the alarm and message printout information stored in the buffer
prior to recording stop is cleared.
<Related Topics> Enabling the batch function: Section 7.24
Setting the number of digits of the lot number and enabling start
printout 2 and end printout 2: Section 7.24
6.14 Setting Up Start Printout and End printout (/BT1 Option)
To Next Page
Loading...
Need help?
General
