IM 04P01B01-01E
10-2
10.1 A List of Error Messages
Code Message Explanation/Countermeasures
64 MATH upper and lower span values are equal. This is not allowed.
70 MATH constant description is incorrect. Incorrect computation constant syntax.
71 The range of the MATH constant is exceeded. –
72 MATH channel is turned off –
81 All space or ‘quit’ string cannot be specified. –
86 The key-lock release password is incorrect. Enter the correct password.
87 This key is locked. –
91 Password is incorrect. Enter the correct password.
100 IP address doesn’t belong to class A, B, or C. –
101 The result of the masked IP address is all 0s or 1s. –
102 SUBNET mask is incorrect. Set a correct subnet mask.
103 The net part of default gateway is not equal to
that of IP address.
Set the correct default gateway.
151 This action is invalid during calculation. –
160 This action is invalid during chart end. –
161 This action is invalid during pen hold. –
162 Cannot set an number for a skipped data. –
163 This action is invalid during record. –
164 This action is invalid during manual printing. –
165 This action is invalid during list printing. –
166 This action is invalid during setup list printing. –
167 This action is invalid during chart feed. –
169 This action is invalid during ribbon hold. –
170 This action is invalid during priority remote record. Recording stop via communications or key operation cannot be
accepted under the current settings. Perform the Stop using the
remote control function.
171 This action is invalid during batch. Cannot enter Basic Setting mode during header printout (until
End printout is finished).
172 Action not executable while accessing SD card. Cannot be executed while the SD memory card is being
accessed.
173 Action not executable while data save is in progress. Cannot be executed while data is being saved.
174 Action not executable while data replay is in progress. Cannot be executed while data is replayed.
175 Ejecting SD card is not possible. The SD memory card cannot be ejected currently. Try again
later.
176 File already exists. Unable to save because a file with the same name already
exists. Change the file name.
177 File does not exist. The specified file does not exist. Check the file name.
178 There is no SD card. Insert the SD memory card properly.
179 Please acknowledge all active alarms. Perform alarm acknowledge operation (alarm ACK).
Operation Errors
Code Message Explanation/Countermeasures
232 There is no available data. There is no data for periodic printout or data for calculating
TLOG when the timer expired.
233 SD card access error. Unable to access the SD memory card. Check that the SD
memory card is inserted properly, that there is enough free
space, and that the card is not locked.
234 The file is damaged. The file is corrupt.
235 The file is not supported. Data replay is not possible because the model, option, or version
is different.
Communication Errors
Code Message Explanation/Countermeasures
300 Command is too long. –
301 Too many number of commands delimited with ’;’. Keep the number of commands separated by sub delimiters
under 10.
302 This command has not been defined. –
303 Data request command can not be enumerated with
sub-delimiter.
–
350 Command is not permitted to the current user level. –
To Next Page
Loading...
Need help?
General
