14
• Rinse (deionized (DI) Water Bottle): DI water, purified water (PW) or water-for-injection (WFI) may be used. If
WFI will be used, it must be cooled to room temperature prior to use.
Failure to use an antiseptic solution approved by YSI may result in voiding parts or all of the
warranty for the Sampling System.
3. Place the reagent and waste bottles near the Multi-Channel Online Monitor (Figure 2-6).
Figure 2-6
4. Connect each reagent bottle line to its respective manifold Luer connector. Figure 2-6 shows the Rinse and
Antiseptic connections, respectively.
5. Connect the end of the waste bottle line to the pump waste tubing female Luer connector on the left side of the
peristaltic pump.
6. Connect the other end of each bottle line to its respective bottle.
7. Ensure all connections are secure and snug.
To Next Page
Loading...
