53
14. For programming additional cycles, select Add Cycle. Another cycle section will be added to the
bottom of the screen. Repeat steps 7 through 13 to program the cycle parameters. Continue the same
procedure for any additional cycles that need to be added to the profile.
15. When all cycles have been programmed, select Save and then select Back. The Scheduler window will
reappear.
16. Turn the Schedule On to activate the profile. The sampling profile will automatically stop at the end of the last
cycle.
4.6.7.2 Editing and Deleting Cycles and Profiles
Profiles may be edited whether the Multi-Channel Online Monitor is running or not. When a parameter is modified,
the change will go into effect immediately after the current sampling cycle is complete.
Profiles can only be removed when the system is not in operation, i.e., Idle mode.
1. Select the Scheduler icon.
2. Click on the profile name that requires editing or removing. The profile window will appear.
To Next Page
Loading...
