6 - 34 TC51 User Guide
3. Plug to power supply into an power outlet.
Figure 6-41 Charging Using the Rugged Charge/USB Cable
Disconnecting the Rugged Charge/USB Cable
To disconnect the Rugged Charge/USB Cable from the TC51:
1. Rotate the device to one side.
NOTE See Power Supply on page 6-42 for information on setting up the power supply.
By default, the device includes an interface connector. If the interface connector is removed for USB Type
C cable connectivity, then it must be replaced before charging or receiving an Ethernet IP address if
placed in a cradle.
To Next Page
Loading...