Introduction
Control Panel Display
28
P1051584-002 8/23/12
Print All Labels
This option prints labels that list the available fonts, bar codes,
images, formats, and the current print engine and network
configurations.
See Print Information on page 84 for more information.
Initialize Flash Memory
This option erases all previously stored information from Flash
memory.
1. If prompted for a password, enter the printer password. For
instructions, see
Changing Password-Protected Parameters
on page 20.
The display shows INITIALIZE FLASH?
2. Press PLUS (+) to select YES.
The display shows ARE YOU SURE?.
3. Do you want to continue?
• Press MINUS (-) to select NO to cancel the request and return
to the
INITIALIZE FLASH prompt.
• Press PLUS (+) to select YES and begin initialization.
When initialization is complete, the control panel displays
INITIALIZING COMPLETED.
Note • Initializing memory can take several minutes.
See Initialize Flash Memory on page 84 for more information.
Print a Sensor Profile
Use this menu item to print a sensor profile.
See Print a Sensor Profile on page 84 for more information.
Calibrate the Media and Ribbon Sensors
Use this menu item to adjust the sensitivity of the media and
ribbon sensors.
See Media and Ribbon Sensor Calibration on page 87 for more
information. For instructions on how to perform a calibration
procedure, see
Calibrate the Ribbon and Media Sensors
on page 99.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
