31
Introduction
Control Panel Display
8/23/12 P1051584-002
Set the Format Command Prefix Value
Set the format command prefix character to match what is used in
your label formats.
See Command Character on page 94 for more information.
Set the Delimiter Character Value
Set the delimiter character to match what is used in your label
formats.
See Delimiter Character on page 94 for more information.
Set the ZPL Mode
Select the ZPL mode that matches what is used in your label
formats.
See ZPL Mode on page 94 for more information.
Set the Ribbon Tension
Select the ribbon tension setting that is appropriate for the width or
type of media being printed. HIGH can be used for most media.
The correct setting is determined by a combination of the ribbon
width and the ribbon length (Table 6). If necessary, use a lower
value for narrow media or for glossy media.
See Ribbon Tension on page 79 for more information.
Set the Power-Up Action
Set the action for the printer to take during the power-up sequence.
See Power-Up Action on page 85 for more information.