Crossbeam
®
340
Crossbeam
®
workstation
Original instructions
Carl Zeiss Microscopy GmbH
Carl-Zeiss-Promenade 10
07745 Jena, Germany
microscopy@zeiss.com
www.zeiss.com/microscopy
Carl Zeiss Microscopy GmbH
Carl-Zeiss-Straße 22
73447 Oberkochen
Document name: Instruction Manual Crossbeam
®
340
Revision: en02(COR)
Effective from: February 2015
© by Carl Zeiss Microscopy GmbH
349500-8022-200
This document or any part of it must not be translated, reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying, recording, or by any information or retrieval system. Violations will be prosecuted.
The use of general descriptive names, registered names, trademarks, etc. in this document does not imply, even in the absence of a
specific statement, that such names are exempt from the relevant protective laws and regulations and therefore free for general use.
Software programs will fully remain the property of Carl Zeiss Microscopy. No program, documentation or subsequent upgrade thereof
may be disclosed to any third party, unless prior written consent of Carl Zeiss Microscopy has been procured to do so, nor may they be
copied or otherwise duplicated, even for the customer’s internal needs apart from a single back-up copy for safety purposes.
Due to an ongoing process of improvement Carl Zeiss Microscopy reserves the right to make modifications of this document without
notice.
To Next Page
Loading...