Name: ZOLL E Series
Brand: ZOLL
Rating: 4 (1 reviews)

To Next Page

To Previous Page

E Series Service Manual

9650-1450-01 Rev. D 5-13

System Board Removal

1. Remove plastic spacer by gently lifting. 2. Remove PCMCIA short connecting ribbon cable from both

sides.

Note: During reassembly verify the spacer ridge sits on board.

3. Remove flat UBP cable from both ends by releasing jams on

each end of the connector, then pull straight out.

4. Gently remove the 2 flat cables by releasing jams on each

end of the connector, then gently pull straight out.

Questions and Answers:

Need help?

Do you have a question about the ZOLL E Series and is the answer not in the manual?

ZOLL E Series Specifications

General