UTILITY
TYP
RvT
PDI
COL
MIX
Rv2
2.4 60
5
40
ttt
tt
(1)
(2)
(3)
(4)
(5)
TYP
RvT
PDI
COL
MIX
ORv2
2.4
60
5
50
The letter
"
H"
is displayed at the left of the display when the
value is changed. The
"1"
mark indicates that the parameter
in the Patch has been changed.
Try
rotating the other
Data
Entry Controls (1
-
3) in the same
way. The parameter values of
(2),
(3)
and (4) in the above
illustration will change.
Note:
Parameter (1) in the chart above will not change even though
the corresponding Data
Entry
Control is rotated. This is a
special parameter which is used
to
select the effect type, and
it
can
be
used only when changing the
type
of effect (for
example, from reverb
to
multi-tap delay) by using the DEC
'I/INC
A
keys.
When
the
effect type is changed, other parameters are also
changed (for example, from the reverb parameters to the
multi-tap delay parameters). Refer
to
Section
IV
for details.
4. Call
up
other pages
by
using the UTILITY/PAGE key.
t
y
p
DES
CTL
(%)
SRC
ORv2
RvT
1
-100
2
Note that new parameters are displayed in positions
(2),
(3)
and
(4).
The parameter values of
(2)
through
(5)
can
be
edit-
ed by using Data Entry Controls
1
-
4 on
this
page,
as
well.
Helpful Hint:
When editing the parameters of the effect module, remember
that the parameters are divided over two or three display
pages.
5.
Return to the first page by pressing the
UTILITYIPAGE key.
The display returns to the first page by pressing the
UTILITY/PAGE key again. (Press the key twice when the
parameters are divided over three pages.)
6.
Call up other modules by using the EDIT
/
>
keys
and edit the parameters as described above.
Helpful Hint:
Remember that the Edit mode consists of
the
following basic
operations:
Selecting the effect module (with
EDIT
c
/
>
keys)
Selecting the effect type (with DEC VIMC
A
keys)
Selecting the page (with UTILITYIPAGE key)
Changing the parameters (with
Data
Entry Controls
1
-
4)
Press the
UTILITY/PAGE
key.
This
calls up another page of
the
REV
effezt module parameters.
To Next Page
Loading...
