Effect
Module
7:
Effect
2
(EFF2)
(3)
MIX
(effect mix):
0
-
100
This determines the mix amount of the effect sounds.
This module features twelve effects, including stereo effects.
Pitch Shifter 2 (PT2)
This is the same effect as Pitch Shifter in EEl.
Phase 2 (PH2)
This is the same effect
as
Phase
in EFF1.
Phase
3
(PH3)
This is a phase shifter for stereo output.
[page
11
(1) DPT (depth): 0
-
100
This determines the depth of the modulation. The greater the
value, the greater the change in the timbre of the sound.
(2)
SPD (sped): 0.1
-
10
HZ
This determines the speed of the modulation,
set
in units of 0.
1
Hz.
(3)
LVL
(output level): 0
-
100
This determines the output level of the module.
[Page 21
(1)
DES
(destination):
DPT,
SPD,
LVL
(2)
CTL
(control change number): 1
-
3
1,63
-
95 (excluding
6,7,70
-
79,
and
91)
(3) RATIO: -100-+10%
(4)
LVL
(output level):
0
-
100
Chorus 2 (CH2)
This is
a
thick mono chorus with a deep, rich effect. Unlike
the Chorus program of EFF1, Chorus
2
lets
you
program the
speed
of
the modulation.
[Page
11
(1)
DPT
(depth):
0
-
100
This determines the depth of the modulation.
(4)
LVL
(output level): 0
-
100
This determines the output level of the module.
[Page
21
(1) DES (destination): DPT, SPD,
MIX,
LVL
(2)
CTL
(control change number): 1
-
3 1,63
-
95
(excluding
6,7,70
-
79, and 91)
(3) RATIO:
-
100
-
+
100%
(4)
LVL
(output level):
0
-
100
Chorus
3
(CH3)
This is a stereo chorus that gives an expansive, spacious feel-
ing. The parameter
data
is the same
as
that of Chorus
2.
Flanger
2
(FL2)
This effect has a wide range of sound variation, which can be
changed manually, and it can
be
also used
as
delayed flanger.
[Page
11
(1) DPT (depth): 0
-
100
This determines the depth of the modulation.
(2)
SPD (speed): 0.1
-
10
HZ
This determines the modulation speed.
(3)
MAN
(manual): 1
-
900
ms
This determines the delay time, set in increments of 1 ms,
with a maximum delay time of
900
ms.
(4)
F.B (feedback):
-98
-
+98
This determines the amount of feedback.
[Page 21
(1) DES (destination): DPT, SPD,
EB,
S
+
F,
LVL
Modulation can
be
set to control both
speed
and
feedback
by
selecting S
+
F.
(2)
CTL
(control change number): 1
-
31,63
-
95
(excluding
6,7,70
-
79, and
91)
(2) SPD (speed): 0.1
-
10
Hz
This determines the speed of the modulation.
(3) RATIO: -100
-
+100%
To Next Page
Loading...
