Pop-up
Menu
What
is
the
Pop-up
Menu?
this example, Patch number 88 is assigned to program
change number 127.)
Releasing the PRG-CHG
LEARN
(DEC V key) returns operation
to
the Play mode.
The popup menu is a menu that lets you assign the settings
Note:
of various functions, such
as
monitoring of the control
This setting is only effective for the table bank which was
change
and
Promm change
numbers*
to
the
PP-llP
selected in
he
Utility mode. (See page 47.)
that they
can
be
immediately called up.
It
is independent
from the other functions of the 9030.
2.
Monitoring
of
the Control Change Number
(CTL-
CHG
MONITOR)
1.
Memorizing Program Change Numbers
(PRG-
CHG
LEARN)
This pop-up menu allows you to view the control change
messages received from an external controller such as the
This
is
a
PoPuP
menu
lhat registers
Or
memorizes
Program
8050 and connected
MIDI
equipment This function is con-
change numbers, received from external equipment venient selecting
be
rea]-time modulation
source,
such
as
the 8050,
into
the program change table.
In
this way,
Patches
can
be
assigned
to
Ihe
program change
In order to
us
this function, MIDI equipment such
as
the
(See
page 46.)
8050 or a synthesizer must
be
connected
to
the
REMOTE
IN
terminal or MIDI
IN
terminal of the 9030.
In order to use this function, MIDI equipment such
as
the
pressed, the display changes
as
shown below.
After you've selected the Patch that is
to
be registered to the
program change table by pressing the PRG-CHG
LEARN
I
1
@EC
Vkey) in the Play mode, then continue holding down
the key. The display changes as shown below when holding
down the PRG-CHG
LEARN
@EC V key).
CTL
-
CHG
MONITOR
CH--
CTL-
-
VAL---
Transmit the control change message from the 8050 or con-
nected MIDI equipment while holding down the
CTL-CHG
MONITOR key on the 9030. The MIDI channel, control
I
I
number and the value of the transmitted control change mes-
sage are indicated at the bottom of the display.
The Patch number of the Patch which is being selected is
indicated
at
the bottom right of the display, and "waiting" is
displayed at the bottom left.
(This
indicates that the
9030
is
waiting for the program change number.) While pressing the
PRG-CHG LEARN (DEC V key), transmit the program
CH
-1
CTL64
VAL127
change message from the 8050 or the connected MIDI equip-
ment. The program change number which is received is
Note:
indicated
at
the
bottom left.
Control change numbers which can be monitored are 0
to
95.
Control change numbers from 96
to
127 are ignored. Control
change numbers from
32
to
64
are indicated as 0 to 31.
When
data
made up of two
bytes
is received, only the upper
data of 0 to
31
are indicated as the value for the control
change number.
(Data
of 32 to
64
are lower.) The
"+"
(arrow) is shown at the right side
of
the value
to
indicate
that
the data is made up of two
bytes.
To Next Page
Loading...
