2.
Press the BYPASS pedal switch of the
8050
again.
I
UTY
3
-
l
MIDI
CH
SEL
CH
=
2
OMNI=bON
4.
Set the
9030
so that it can be controlled from the
REMOTE
terminal,
Call up the MIDI/Remote Mode page in the Utility mode and
select "REMOTE
MODE."
UTY
3
-
4
MIDI/
RMT
MODE
1
P
REMOTEMDE
5.
Return to the Play mode by pressing the
EXIT
key.
Selecting a Patch from the 8050
This section explains how
to
select a Patch of the 9030 from
the 8050.
1.
Register beforehand the Patch and the program num-
ber to be used
in
the program change table
of
the
9030.
Helpful
Hint:
Use
the program change learn function (PRG-CHG LEARN)
of the pop-up menu for assigning the values. (See page 50.)
2.
Transmit the program change message by using the
BANK
pedal switch UPiDOWN, GROUP pedal switch
and number pedal swich
1
-
5
of
8050.
The 9030 switches to the appropriate Patch according to the
assignment
in
the selected program change table.
Bypassing
All
Effects from the 8050
It
is
possible
to
bypass
all
effects of the 9030
by
using the
BYPASS pedal switch of the 8050.
1.
Press the BYPASS pedal switch of the
8050.
The effect bypass function
is
released.
Turning
Off
Each Effect Module from the
8050
It is possible
to
turn
off each 9030 effect module indepen-
dently by using the Extended mode of the 8050.
1.
Set the
8050
to the Extended mode, and select the
pup CONT with GROUP pedal switch.
Now all the number pedals of the 8050 can be used as con-
trol pedals. The control number of each
pedal
of 8050 has
been programmed at the factory
to
switch off
a
specific effect
module of the 9030 according to the assignments shown
below.
Number
pedal
switch
1
--
CMP
(control change number 70)
Number
pedal
switch
2
--
DST
(control change number 72)
Number
pedal
switch
3
--
EFFl/SFX (control change number 75)
Number
pedal
switch
4
--
EFF2
(control change number 76)
Number
pedal
switch
5
--
REV (control change number 77)
2.
Press down number pedals
1
-
5
of the
8050
several
times while playing the connected musical instrument.
Notice that the various effect modules of the 9030 are turned
on and off
as
you press the pedals.
Helpful
Hint:
You can also bypass other effect modules by changing the
control change number of the BYPASS pedal of the 8050.
All the effects of the 9030 are now bypassed. This operation
is exactly the same
as
pressing the BYPASS key on the 9030.
At the moment the
BYPASS
pedal switch of 8050 is pressed
down, control change number 91 is sent
to
9030. This con-
trol change number is compatible with the bypass function of
the 9030 and
can
be
used
in this way.
To Next Page
Loading...
