Zoom 9030 - Selecting the Table Bank; Setting the MIDI;Remote Mode; MIDI out Mode

3-3 Selecting the Table Bank
3-4 Setting the MIDIIRemote Mode
The program change table is selected from four banks, A - D,
in this display.
1 UTY3 - 3 TABLE BANK
TABLE BANK+A
:
You can create four separate program change tables, labeled
A through
D, for convenient selection of different program
change/Patch assignments.
To call up one of the banks for
setting or normal use, press the DEC
V/INC A keys.
(1) Bank name -- For selection of the bank name (A - D).
Helpful Hint:
This function is convenient for pre-programming several dif-
ferent banks, each designed for a different performance or
recording application. Once you've programmed the banks,
simply select
a bank when you need it, and the 9030 com-
pletely reconfigures the program changepatch assignments.
Functions of the Panel Keys
UTILITY key -- Moves to page 4 (Patch recall).
DEC V/INC A keys -- Set the parameter values.
EDIT c / > keys -- Move the cursor. Pressing the EDIT c
key calls up display page 3-2, and pressing the EDIT > key
calls up page
3-4 (setting mode).
This page allows you to select the terminal, remote or MIDI,
by which the 9030 will
be remotely controlled.
b MIDI OUT MODE
Three modes are available in this page, as described below.
The function of the MIDI OUT terminal changes depending
on the mode selected.
MIDI OUT MODE -- In this mode, the 9030 can be
remotely controlled by data received via the MIDI IN termi-
nal. (The
REMOTE terminal cannot be used.) In this case,
the MIDI
OUT terminal functions normally (as a MIDI OUT
terminal). However, this received data is not output. System
exclusive data can
be transmitted through the MIDI OUT ter-
minal.
MIDI THRU MODE -- In this mode, the 9030 is remotely
controlled by
data received via the MIDI IN terminal. (The
REMOTE terminal cannot
be used.) In this case, the MIDI
OUT terminal functions as a MIDI THRU terminal. Data
originating from the 9030 cannot
be transmitted.
REMOTE MODE -- In this mode, the 9030 is remotely
controlled by data received via the REMOTE terminal.
(Remote control via the MIDI terminals is not possible in
this mode.)
The MIDI
OUT terminal functions as a MIDI
THRU terminal, outputting the signals received via the
REMOTE terminal.
Functions of the Panel Keys
.UTILITY key -- Moves to the next page (Patch recall).
DEC WINC A keys -- Set the parameter values.
EDIT < 1 > keys -- Pressing the EDIT c key moves back to
page 3-3, and pressing the EDIT > key moves to page 3-5
(MIDI Bulk Dump).