Zoom 9030 - MIDI;Remote Setup; Selecting the MIDI Channel (MIDI CH SEL); Setting the Program Change Table

3. MIDIJRemote Setup
3-2 Setting the Program Change Table
This page lets you make settings for MIDI and the ZOOM
remote terminal. (These two settings cannot be made sepa-
rately.) Since there are many parameters to be set in this
page, the page is actually divided into five smaller sub-pages
(3- 1 - 3-6). The EDIT < / > keys is used to move among the
sub-pages.
3-1 Selecting the MIDI Channel (MIDI CH SEL)
This is the display page for setting the MIDI receive channel.
l UTY 3 - 1 MIDI CH SEL
CH =b 1 OMNI= ON
(1) MIDI channel -- This determines the MIDI channel
over which the 8050 transmits and receives program change
and control change messages. The range is 1 - 16.
(2) Omni onloff -- When omni is set to ON, messages over
all MIDI channels are received regardless of the MIDI chan-
nel settings.
Match the MIDI send channel of
your MIDI controller with
the
MIDI receive channel of the 9030, or set omni to ON
when remotely controlling the
9030 from the 8050 or other
MIDI equipment.
Functions of the Panel Keys
This page is used to set the program change table.
UTY 3 - 2 PRG - CHG TABLE
A: PRGb 127 =PATCH 99
(1) (2)
The program change table is a convenient remote control
feature of the 9030 that allows you
to assign any MIDI pro-
gram change number (0 - 127) to any Patch number (1 - 99)
of the 9030.
(1) Program change number -- This determines the pro-
gram change number which is assigned to a 9030 Patch.
(2)
Patch number -- This determines the Patch number of
the 9030 to which the above program change number is
assigned.
Functions of the Panel Keys
UTILITY key -- Moves to the next page (Patch recall).
DEC V/INC A keys -- Set the parameter values.
EDIT
1 > keys -- Move the cursor. Pressing the EDIT C
key when the cursor is at the PRG parameter calls up display
page 3-1; pressing the EDIT
> key when the cursor is at the
Patch parameter calls up page 3-3 (selection of table bank).
Helpful Hint:
It is also possible to easily set the program change table by
using the pop-up menu. See page 50 for more information.
UTILITY key -- Moves to page 4 (Patch recall).
DEC V/INC A keys -- Set the parameter values.
EDIT / > keys -- Move the cursor. Pressing the EDIT >
key when the cursor is at the OMNI parameter calls up clis-
play page
3-2.