following modules is mono or stereo.
(4) LVL (output level): 0
-
100
[Page
21
(1)
DES
(destination): DPT, LVL
(2)
CTL
(control change number): 1
-
31, 63
-
95 (exclud-
ing 6,7,70
-
79, and 91)
(3)
RATIO:
-100
-
+100%
(4)
LVL (output level):
0
-
100
Note:
When the
SFX
effect module is used, the stereo switch
parameter is unavailable.
Effect
Module
6:
Effect
1 (EFFI)
This module features twelve mono effects.
Pitch Shifter (PIT)
This effect alters the pitch of the effect sound over a range of
two octaves.
[Page
1
l
(1)
PIT
(pitch): -12
-
+l2 half-steps
This determines the number of half-steps by which the pitch
of the input signal is changed. The range is from one octave
below
to
one octave above
the
input pitch.
(2)
FIN
(fine): -50
-
+50 cents
This allows fine tuning of the pitch-shifted note, in units of 1
cent
(11100 half-step).
(3)
B
AL
(balance): 0
-
100
This determines the level balance of the direct sound and
pitch-shifted sound. Only the direct sound is output at 0, and
only the pitch-shifted sound is output at 100.
(4)
LVL (output level):
0
-
100
This determines the output level of the module.
[Page 21
(1) DES (destination): PIT,
FIN,
BAL,
LVL
(2)
CTL
(control change number):
1
-
31,63
-
95
(exclud-
ing 6,7,70
-
79, and
91)
Phase (PHA)
This is a warm and natural phase sound.
[Page
11
(1) DPT (depth): 0
-
100
This determines the depth of the tone change. The
greater
the value, the greater the change
in
the timbre of the sound.
(2)
SPD
(speed): 0. l
-
10
Hz
This determines the speed of the modulation effect, set in
increments of 0.1
Hz.
(3)
PK
(peak):
0
-
100
This determines the emphasis or the special characteristics of
the sound.
(4) LVL (output level):
0
-
100
This determines the output level of the module.
[Page
21
(1) DES (destination): DPT, SPD, D+S,
LVL
This determines the destination of the modulation effect.
Modulation can
be
applied
to
both depth and speed when
"D
+
S"
is selected.
(2)
CTL
(control change number):
1
-
31,63
-
95 (exclud-
ing 6,7,70
-
79, and 91)
(3)
RATIO:
-100 -+loo%
(4)
LVL
(output level): 0
-
100
Fianger
(FLG)
This flanger is capable of a wide range of modulation effects,
from a
warm
and subtle chorus to
an
intense, swirling flang-
ing sound.
[Page
11
(1) DPT (depth): 0
-
100
This determines the depth of the tone change.
The greater
the value, the greater the change
in
the timbre of the sound.
(2) SPD (speed): 0.1
-
10
HZ
This determines the speed of the modulation effect, set in
increments of 0.1
Hz.
(3)
RATIO:
-10-+loo%
To Next Page
Loading...
