Remote control and real-time modulation of the 9030
can
be
accomplished by using MIDI equipment such
as
the 8050
(optional) or other
MIDI
instruments.
Controlling
the
9030
from
the
8050
With
the
8050 foot controller, you can switch among the
Patches of the 9030
and
bypass specific effect modules by
using your
foot.
You can
ah
control effect parameters of
the 9030
in
real
time by connecting the
FPOl
expression
ped-
al
to
the
8050.
Equipment Connections and Settings
1.
Connect the 8050
and
the 9030.
Connect the
REMOTE
OUT erminal of the 8050 to the
REMOTE
IN
terminal of the 9030 by using the remote cable
(RC05) included with the 8050. The 8050 does not require
an
AC
adaptor, since power is supplied from the 9030
through the
REMOTE
terminal.
2.
Set the 8050
as
shown below.
MIDI send channel:
1
Mode:
Standard
mode
Control change number of expression
pedal
1:
No.
7
Control change number of expression
pedal:
No.
1
Control change number of
BYPASS
pedal switch: No. 9
1
The above settings are programmed at the factory. You need
not carry out this operation if the settings have not been
changed.
3, Make sure that the MIDI receive channel of the 9030
and the MIDI send channel
of
the 8050 are the same,
Call up the page for selecting the MIDI channel in the Utility
mode and either set the MIDI channel
to 1
or set OMNI
to
ON.
The display below appears when the MIDI channel is set
to
1.
l
UTY
3
-
1
MIDI
CH
SEL
CH
=P
1
OMNI=
OFF
The display on the next page appears when the MIDI chan-
nel is set
to
omni on.
Instrument Amplifier
L
I
I
OUTPUT
INPUT
-
R
REMOTEIN
DC9V
REMOTE
I
OUT
To Next Page
Loading...
