Zoom 9030 - Effect Module Descriptions: Distortion Effects; Distortion, Overdrive, and Crunch

Overdrive (OD)
(3) RATIO: -100- +100%
(4)
LVL (send level): 1 - 10
Effector
"m
I RETURN SEND I
Note:
When connecting the 9030 to an external effect, make sure to
always keep the external effect on, and switch it on and off
from the 9030.
Effect Module 3: Distortion (DIST)
This module features three distortion effect types.
This effect reproduces the natural distortion of a
tube ampli-
fier with the controls at full throttle.
[Page 11
(1) DRV (drive): 1 - 13
This determines the degree of the overdrive effect. The
greater the value, the greater the amount of overdrive.
(2) EQ (equalizer): l - l0
This determines the sound color or timbre of the distortion.
The greater the value, the more the higher frequencies are
emphasized.
(4) LVL (output level):
0 - 100
This determines the output level of the module.
[Page 21
(1) DES (destination): DRV, EQ, LVL
(2)
CTL (control change number): 1 - 31, 63 - 95 (exclud-
ing 6,7,70
- 79, and 91)
Distortion (DST)
(3) RATIO: -100 -+loo%
Hard analog distortion.
(4)
LVL (output level): 0 - 100
Page 11
(1) DST (distortion): 1 - 13
This determines the strength of the distortion. The greater
the value, the greater the distortion.
(2) EQ (equalizer): l - l0
This determines
the sound color or timbre of the distortion.
The greater the value, the more the higher frequencies are
emphasized.
(4)
LVL (output level): 0 - 100
This determines the output level of the module.
[Page 21
(1) DES (destination): DST, EQ, LVL
(2) CTL (control change number): 1 - 31, 63 - 95 (exclud-
ing 6,7,70
- 79, and 91)
(3) RATIO: -100 - +100%
Crunch (CRU)
This effect produces a slightly distorted tube amplifier
sound. It is suited for clipped guitar chords and repeated sin-
gle notes.
[Page 11
(1) DRV (drive): 1 - 13
This determines the degree of the overdrive effect.
(2) EQ (equalizer): 1
- l0
This determines the sound color or timbre of the distortion.
The greater the value, the more the higher frequencies
are
emphasized.
(4) LVL (output level): 0 - 100
This determines the output level of the module.
[Page 21
(1) DES (destination): DRV, EQ, LVL
(4) LVL (output level): 0 - 100
(2)
CTL (control change number):
1 - 31, 63 - 95 (exclud-