4.
Patch Recall
This function is
used
to
call up a Patch from the recall buffer.
(See page 4
1
for more information on the recall buffer.)
UTY4 PATCH RECALL
/
EDIT RECALL
OK?
UTY5 ROM PATCH CALL
01
DOUBLEWAH
?
Select the Patch by using the DEC
V/INC
A
keys and
actu-
ally load it by using the STOREEXECUTE key. Operation
automatically returns to the Play mode after the loading is
completed. (The
"
B"
mark in
the
display lights up, indicat-
ing that the Patch is being edited.)
The following Patches can
be
recalled by this function:
Functions of the Panel Keys
The Patch which was last being edited before selecting a
new Patch in the Play mode.
The Patch which was last being edikd before selecting a
ROM
Patch. (See page 41.)
Functions of the Panel Keys
UTILITY key
--
Moves
to
page
5
(ROM Patch Call).
STORE'EXECUTE key
--
Executes the Patch Recall.
Helpful Hint:
This function
is
convenient when you have selected a new
Patch but have forgotten to store the previous Patch that you
were editing. You may want
to
store the Patch
to
memory
since Patches in the
recall
buffer are transferred to
the
edit
buffer when the Patch recall function is executed.
When
there
is a edited patch in the edit buffer, the message
"Are you sure
?
"is displayed for confirmation. Press the
STORE/EXECUTE key again and the Patch recall function
is
executed.
5.
Calling
Up
Patches from ROM (ROM Patch
CALL)
There are 99 different Patches available in the ROM (Read
Only Memory) of the 9030. The
data
in ROM is permanent;
data
can
be
read from ROM, but not written
to
it. Patches in
ROM cannot
be
called up by normal operations. From this
display, check the sound of the Patches one by one, then
transfer them individually
to
the edit buffer.
Helpful Hint:
The Patches in ROM are the same as the ones which are
loaded to
the
internal memory at the factory. Even if you
mistakenly
edit
a Patch which you often use, you
can
restore
the original Patch from this display.
UTILITY key
--
Moves
to
page
6
(adjustment of the dis-
play brightness).
DEC
VIINC
A
keys
--
Select the Patch to
be
read
from
ROM.
STOREtEXECUTE key
--
Loads
the selected Patch.
Note:
The Patch which is called up with this operation is trans-
ferred to the edit buffer. If you wish to keep this Patch or
edit it, you should store it to memory.
6.
Adjusting the Display Brightness (DISPLAY
DIMMING)
This display lets you adjust the brightness of the
FL
display.
Change this setting when studio or stage lighting conditions
make the display difficult to read.
1
UN6 DISPLAY DIMMING
DIMMING=P60%
The brightness of the display can be adjusted by
using the
DEC
V/INC
A
keys. The value can
be
changed
in
five
20-
percent steps, from
20%
to 100%.
Functions of the Panel Keys
UTILITY key
--
Returns to the first page.
DEC VRNC
A
keys
--
Adjusts the brightness.
To Next Page
Loading...
