Zte ZXR10 ZSR V2 - Ipv6 Routing Policy Configuration Instances; Figure 9-1 an Example of Configuring a Routing Policy for Redistributing Ripng Routes

Chapter9IPv6Route-MapPolicyConguration
CommandDescription
ZXR10(config)#showrunning-configvrfDisplaystheVRFrouteconguration.
ZXR10(config)#showipvrfdetail
[<vrf-name>]
DisplaystheVRFconguration.Youcanspecifya
VRFinstance,andqueryitsconguration.
ZXR10(config)#showroute-map
[<route-map-name>]
Displaystheroute-mapconguration.
–EndofSteps–
9.1.2IPv6RoutingPolicyConfigurationInstances
9.1.2.1Example:ConfiguringaRoutingPolicyforRedistributingRIPngRoutes
CongurationDescription
BothR1andR2runtheRoutingInformationProtocol(RIP),seeFigure9-1.Thisenables
theirRIPngroutestobeadvertisedtoeachother,andothertypesofroutestobe
redistributed.Thefollowingshowsanexampleofredistributingstaticroutes.
Figure9-1AnExampleofConguringaRoutingPolicyforRedistributingRIPngRoutes
CongurationFlow
1.EnableIPv6andsetIPv6addressesonthecorrespondinginterfacesofR1andR2.
2.EnabletheRIPngprotocolcongurationontheinterfaces.
3.Redistributeothertypesofroutes,andcreatearedistributioncommand.
4.Associatetheredistributioncommandwitharoute-map.
5.Settheroute-map.
6.Querythecongurationresult,andverifythatR1andR2canlearnroutesthatthepeer
advertises.
CongurationCommands
CongurationonR1:
R1(config)#interfacegei-1/2
R1(config-if-gei-1/2)#noshutdown
R1(config-if-gei-1/2)#ipv6enable
R1(config-if-gei-1/2)#ipv6address192:168::1:1/64
R1(config-if-gei-1/2)#exit
9-7
SJ-20140504150128-018|2014-05-10(R1.0)ZTEProprietaryandCondential