Zte ZXR10 ZSR V2 - Configuring the DHCPv6 Server

ZXR10ZSRV2CongurationGuide(IPv6)
Steps
1.EnabletheDHCPv6function,andsettheDHCPv6modeoftheinterfacetoDHCPv6
Server.
StepCommandFunction
1ZXR10(config)#dhcpipv6EntersDHCPv6conguration
mode.
2ZXR10(config-dhcpv6)#enableEnablestheembedded
DHCPv6function.
3ZXR10(config-dhcpv6)#interface<interface-name>EntersDHCPv6interface
congurationmode.
4ZXR10(config-dhcpv6-if-interface-name)#mode
{server|relay}
EnablesDHCPv6working
modeofaninterface.
2.ConguretheIPv6addresspool.
StepCommandFunction
1ZXR10(config)#ipv6addr-pool<pool-name>EntersIPv6addresspool
congurationmode.
2ZXR10(config-ipv6-addr-pool)#addr-range
<start-ipv6><end-ipv6>[vrf-instance<vrf-name>]
Congurestherangeofthe
IPv6addresspool.
3ZXR10(config-ipv6-addr-pool)#exclude-range
<start-ipv6><end-ipv6>[vrf-instance<vrf-name>]
ConguresIPv6reserved
addresses.
4ZXR10(config-ipv6-addr-pool)#conflict-time
<timeout>
Conguresthereleasetime
(inminutes)ofconicting
addressesintheIPv6address
pool,range:1to18000,
default:30.
5ZXR10(config-ipv6-addr-pool)#lockLockstheIPv6addresspool,
default:unlocked.
6ZXR10(config-ipv6-addr-pool)#threshold<percent>Conguresthealarm
thresholdoftheIPv6address
pool,range:50to100,
default:100%.
3.CongureIPv6prex-pool.
StepCommandFunction
1ZXR10(config)#ipv6prefix-pool<pool-name>EntersIPv6prex-pool
congurationmode.
24-4
SJ-20140504150128-018|2014-05-10(R1.0)ZTEProprietaryandCondential